For removing tube stubs from the tube sheets.

Available for tubes from 1/2” to 1 1/2” O.D. (12.7 mm to 38.1 mm) O.D.

For reducing the tube wall in condensers and heat exchangers
to facilitate collapsing.

Available for tube 1/2” to 1 1/2” O.D. (12.7 mm to 38.1 mm) O.D.

Designed for collapsing the tube in the tube sheet after the tube wall is reduced with the tube wall reducing tool.

Suitable for tubes O.D. from 1/2” to 1 1/2” (12.7 mm to 38.1 mm) O.D.

 
Suitable for cutting steel and non-ferrous tubes in condensers, heat exchangers and boilers.

Adjustable for tube sheet thickness from 2” to 6” (50.8 mm to 152.4 mm).

Available for tubes from 1/2” to 2 1/2” (12.7 to 63.3 mm) O.D..

 
For sealing off leaky condenser and heat exchanger tubes without damaging tube sheets.

Tapered pin is driven into ring, which is tapered on the inside and is parallel to tube on the outside.
This gives even expansion to the ring and a long contact to the seal.

Available in a variety of metals.

Specify Tube O.D. and Gauge.

NOTE: Puncture the tube to ensure that pressure cannot build up in the tube and cause the plugs to loosen or blowout.

 
Ideal for sealing leaky tubes in condensers or heat exchangers.

Just drive a plug into each end of leaky tube.

Available in a variety of metals.

Specify Tube O.D. and Gauge.

NOTE: Puncture the tube to ensure that pressure cannot build up in the tube and cause the plugs to loosen or blowout.

TECO produces a range of “TECO PLUG” tube plugs.

Which are used in heat exchangers to maintain a safe and leak-tight seal under the most severe conditions.

The TECO Plugs are used in leaking tubes or as a preventive seal.

The TECO plugs are characterized by the simple, quick and especially safe installation, and also the extreme durable character of this system.

Are available for tube sizes 5/8” – 1 1/8” OD (16 – 28 mm).

Other sizes and/or special body tip for larger walls are optional.

Standard adjustable reach of 4 7/16” (110 mm) with optional longer reaches available.

“A” Reach = 7 7/16” (188 mm),
“C” Reach = 10 15/16” (277 mm).

Increase your productivity with the TECO air-driven Cutter Feed Assist.

The Cutter Feed Assist is designed to aid the TECO PTC Push Type Tube Cutters for OD tube sizes of 5/8” through 1” (15.9 - 25.4 mm).

Powered by an air-driven variable speed drill.

This newly designed tool is used for extracting tubes
from the tube sheet holes.

Without damaging the tube sheet holes.

Available for tubes from 1/2” to 1 1/2” (12.7 mm to 38.1 mm) O.D.